Tuesday, July 23, 2019

Hydrolics Lab Report Example | Topics and Well Written Essays - 1500 words

Hydrolics - Lab Report Example Pressures are examined at low, mid and also at high flow conditions. The spillway is one of the most important structures that should be given priority in a dam project. Spillways constructed along with the dams help in controlling excess water or flood hence ensuring the safety of the project. It is also vital that the design of the spillway facilities be done with enough capacity to help avoid overtopping of the dam, especially where an earth fill or rock fill dam type is used for the purpose of the project. The ogee-crested spillway has superior hydraulic characteristics. It has the ability to pass flow efficiently and safely when it is properly designed, with good flow measuring capabilities and this has enabled its application in a variety of situations by engineers. Though much is understood about the ogee shape and about its flow characteristics, it is also clear that a slight deviation from any conventional design parameter like change in the upstream flow conditions, a slightly modified crest shape or construction variations can significantly alter properties of the flow. These minor adjustments require that engineers carry out evaluation of the crest and also to determine whether the change or deviation will adversely affect the performance of the spillway or not. The ski jump spillways are basic in their design as they transfer the excess water from behind the dam. They usually have a â€Å"flip lip† and a dissipater basin which helps create a hydraulic jump and therefore protecting the toe of the dam from erosion. . An Ogee spillway was properly installed and the highest discharge was chosen and then using the weir boards, we created a USBR Type 1 stilling basin, with a hydraulic jump being within the stilling basin. We also ensured that the gradient on the flume was set at 3%. †¢ . Similarly a ski jump spillway was properly installed and the highest discharge was chosen and then using the weir boards, we created a USBR Type 1 stilling

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.